10mm Longboard Bearing Spacers – 10.2mm ID × 14mm OD × 12.5mm L

10mm Extended Longboard Bearing Spacers – 12.5mm Length

Custom-length bearing spacers designed for TorqueBoards longboard wheel setups using 10mm axles.

These spacers measure 10.2mm inner diameter × 14mm outer diameter × 12.5mm long. Their extended 12.5mm length is approximately 2.5mm longer than many common 10mm longboard bearing spacers.

TorqueBoards uses these spacers with specific longboard wheel and axle configurations that require additional spacing between the wheel bearings.

Key Features

• Designed for 10mm axle setups
• Extended 12.5mm spacer length
• 10.2mm inner diameter
• 14mm outer diameter
• Custom fit for compatible TorqueBoards longboard configurations
• Installs between the inner bearing races
• Helps support proper bearing alignment when axle hardware is tightened

Specifications

• Inner diameter: 10.2mm
• Outer diameter: 14mm
• Length: 12.5mm
• Axle size: 10mm
• Application: Longboard and electric skateboard wheel assemblies
• Style: Extended-length bearing spacer

Why These Spacers Are Different

Many conventional longboard bearing spacers are approximately 10mm long.

These TorqueBoards spacers are 12.5mm long, providing an additional 2.5mm of spacing for wheel and axle setups that require a wider distance between the inner bearing races.

They are not intended as universal replacements for every skateboard or longboard wheel.

Compatibility

Designed for compatible TorqueBoards longboard setups using our specific axle and wheel configuration.

They may also work with other longboard or electric skateboard assemblies requiring:

• A 10mm axle
• A 10.2mm spacer inner diameter
• A 14mm spacer outer diameter
• A 12.5mm distance between the bearing inner races

Measure your existing spacer or the internal bearing spacing before ordering.

Do not assume compatibility based only on axle diameter.

Why Bearing Spacers Matter

A correctly sized spacer supports the inner bearing races when the axle nut is tightened.

Using an incorrect spacer length may cause:

• Bearing side loading
• Restricted wheel rotation
• Wheel play
• Premature bearing wear
• Improper wheel alignment

The correct spacer should fit securely between the two bearings without being too short or too long.

Installation

Install one spacer between the two bearings inside each compatible wheel.

After installation:

• Tighten the axle hardware correctly
• Confirm the wheel rotates freely
• Check for excessive side-to-side movement
• Verify the bearings are fully seated
• Stop and recheck the setup if the wheel binds after tightening

What’s Included

State the exact quantity here, for example:

• 4x - 10mm extended longboard bearing spacers

Bearings, wheels, axles, and mounting hardware are not included.